Troubleshooting - JVC KW-R910BT Manuel D'instructions

TROUBLESHOOTING

Symptom Remedy
Sound cannot be heard. • Adjust the volume to the optimum level.
• Check the cords and connections.
"MISWIRING CHK WIRING THEN Check to be sure the terminals of the speaker wires are
RESET UNIT" / "WARNING CHK insulated properly, then reset the unit. If this does not
WIRING THEN RESET UNIT" solve the problem, consult your nearest service center.
appears and no operations can
be done.
Source cannot be selected. Check the [SRC SELECT] setting. ( 4)
Radio reception is poor. / • Connect the antenna firmly.
Static noise while listening to • Pull the antenna out all the way.
the radio.
Correct characters are not This unit can only display uppercase letters, numbers,
displayed. and a limited number of symbols. The unit can also
display uppercase Cyrillic letters. ( 17)
"PLEASE" and "EJECT" appear Press , then insert the disc correctly.
alternately.
"IN DISC" appears. Make sure nothing is blocking the loading slot when you
eject the disc.
Disc cannot be ejected. Press and hold
to drop the disc when it is ejected.
Playback order is not as The playback order is determined by the file name (USB)
intended. or the order in which files were recorded (disc).
Elapsed playing time is not This depends on the recording process earlier.
correct.
"NOT SUPPORT" appears and Check whether the track is a playable format. ( 16)
track skips.
18
to forcibly eject the disc. Be careful not
Symptom Remedy
"CANNOT PLAY" flashes and/ • Check whether the connected device is compatible with
or connected device cannot be this unit and ensure the files are in supported formats.
detected. ( 16)
• Reattach the device.
"READING" keeps flashing. • Do not use too many hierarchical levels and folders.
• Reload the disc or reattach the USB device.
The iPod/iPhone does not turn • Check the connection between this unit and iPod/
on or does not work. iPhone.
• Detach and reset the iPod/iPhone using hard reset.
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. ( 3)
Pairing cannot be made. • Make sure you have entered the same PIN code to both
the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. ( 9)
"PAIRING FULL" appears. The number of registered devices has reached its limit.
Retry after deleting an unnecessary device. ( 13,
DELETE PAIR)
"PLEASE WAIT" appears. The unit is preparing to use the Bluetooth function. If
the message does not disappear, turn off and turn on
the unit, then connect the device again.
"BT DEVICE NOT FOUND" The unit failed to search for the registered Bluetooth
appears. devices during [AUTO CNNCT]. Turn on Bluetooth from
your device and connect manually. ( 13)
Echo or noise occurs. • Adjust the microphone unit's position. ( 9)
• Check the [ECHO CANCEL] setting. ( 11)
Phone sound quality • Reduce the distance between the unit and the
is poor. Bluetooth device.
• Move the car to a place where you can get a better
signal reception.