Establishing The Electrical Connection En - Abicor Binzel BRS-CC Guide D'installation

6 Putting into operation
6.8 Establishing the electrical connection
Four 24 V DC robot outputs and one 24 V DC robot input are required to control the valves.
NOTICE
The cleaning station must be and remain without compressed air and tension during setup!
• The gas nozzle diameter must match that of the prism.
• The distance sleeve must match the nominal diameter of the gas nozzle.
• The reamer must be precisely aligned with the torch type.
lmax < 200 mA
lmax < 200 mA
lmax < 200 mA
lmax < 200 mA
lmax < 200 mA
Fig. 10 Electrical connection
EN - 16
24 V DC
GND
Injection
Stroke
Cutter
Valves: clamp, motor
Signals: stroke down
BRS-CC