Burners" Technical Data Table; Rules For Converting And Installing For Other Types Of Gas; Substituting The Nozzle In Open Cooking Rings; Changing The Oven Burner Nozzle - Lotus cookers PCT-63G Instructions Pour L'installation Et L'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Burner max 3,5 KW-min 1,2kW

Burner Injector 1/100 mm

Min. output adjustment 1/100 mm

Consumption

Primary air h=mm

Burner max 5,5 KW-min 1,8kW

Burner Injector 1/100 mm

Min. output adjustment 1/100 mm

Consumption

Primary air h=mm

Oven burner max. 4 kW -min 1,15 kW

Burner injector 1/100 mm

Min. output adjustment 1/100 mm

Consumption

Primary air h=mm

Grill burner max 4 kW

Burner injector 1/100 mm

Consumption

Primary air h=mm

RULES FOR CONVERTING AND INSTALLING FOR OTHER TYPES OF GAS

Our appliances are tested and regulated with liquid gas (see data plate).

The conversion or adaptation to another type of gas must be carried out by a specialized technician. The nozzles for the

various types of gas are supplied in a packet and are marked in hundredths of mm (see "burners" technical data table).

SUBSTITUTING THE NOZZLE IN OPEN COOKING RINGS

Remove the grills, the burners and the containers, substitute the nozzles with the right ones, using a suitable spanner,

unscrewing the blockage screw and relative jam nut. After regulating, screw back the screw and the jam nut, regulate

minimum output by turning the screw to the right or to the left until the thermal power reaches 1,2 KW for the burner of

3,5 KW, and 1,8 for the burner of 5,5 KW.

Warning: For functioning with liquid gas, the screw for regulating minimum output must be blocked completely.

To change the oven nozzle proceed as follows:

•

Remove the bottom oven panel;

•

Unscrew both securing screws from the burner (see Fig.E), pull it out and unhook it,

•

Substitute the nozzle using a suitable spanner (2) (see the "Technical Data" table).

•

After this procedure, fix the burner again.

•

Regulate the air regulating bush (4) to the corresponding value given in the "technical data" table, unscrewing

the securing screw with relative check nut, regulate the minimum by turning the screw (Fig.F, 1) to the right or

left until the thermal power reaches 1,15 kW: this procedure is possible only after having let the oven burner

work at maximum output for about 20 minutes.

Then turn the thermostat round to the minimum position and adjust.

After regulating, check lighting at both maximum and minimum output. Make sure that, when changing

rapidly from minimum to maximum output, the flame does not present any problems and does not go out when

closing or opening the oven door quickly.

Warning: When working with liquid gas the regulating screw must be screwed right down.

To change the nozzle unscrew the securing screws, move the burner to the right and unhook it. Unscrew the nozzle

(2) with a suitable spanner and change it (see the "Technical Data" table). Regulate the air regulating bush (4) to the

corresponding value given in the "Technical Data" table, unscrewing the securing screw with relative check nut. No

adjustment is necessary for the minimum output because the burner works only with a fixed flame.