Jennair Rise JGRP648HL Instructions D'installation page 25

8. Apply masking tape to the end of a 1/4" (6.4 mm) nut driver
to help hold the gas orifice spud in the nut driver while
changing it. Insert nut driver into the gas opening, and press
down onto the gas orifice spud, then remove by turning the
gas orifice spud counterclockwise and lifting out. Set gas
orifice spud aside.
A
A. Gas orifice spud
9. Gas orifice studs are stamped with a letter and a number.
Install the Number 105 oven bake burner orifice spud.
10. Place Natural gas orifice in plastic parts bag for future use,
and keep with package containing literature.
11. Push down on the clip on the electrode bracket.
B
A
A. Oven bake burner electrode bracket
B. Electrode bracket clip
12. Replace oven bake burner electrode inside bracket.
B
A
A. Oven bake burner electrode
B. Oven bake burner electrode bracket
13. Reinstall the oven bake burner and oven bake burner
screws. See Step 5 for illustration.
Replace Oven Bake Burner Cover
1. Align rear shoulder screw mounting holes (keyholes) on the
oven bake burner cover with shoulder screws in the bottom
of the oven.
A. Shoulder screw mounting holes (keyholes)
B. Shoulder screws
2. Drop cover and slide to left or right to slide shoulder screws
into narrow ends of keyholes, and lock into place.
A
A. Bake burner cover
A
B
25