Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Clicking or popping sounds when switching inputs
•
The unit uses relay switching to preserve maximum sound quality. The
mechanical clicking of the relays is normal.
•
Switching between HDMI sources may cause delays as HDMI two way
communications "handshake" must be established between the source
and display. The time required for the handshake varies depending
on the attached equipment.
Controls do not operate
•
Make sure that fresh batteries are installed in the remote.
•
Make sure that the IR sensor on the front panel is not blocked. Aim the
remote control at the sensor.
•
Make sure the sensor is not receiving strong IR light (sunlight, halogen
lighting, etc.).
•
Unplug the unit from the AC outlet, wait 30 seconds, and plug it
back to reset.
•
Confirm the IR Codeset set in the remote control and RSP-1582 are
matched to either Codeset 1 or Codeset 2.
31
Publicité
Chapitres
Table des Matières
