Operation Instructions - Technibel DG12C Notice D'emploi

OPERATION INSTRUCTIONS

● Start Operation
1) Make sure the plug is firmly plugged on in the socket.
2) Make sure the water tank is placed in proper position.
(After plug on the mechine for the first time, if the full
tank lamp light up, just pull out the water tank then
push it back to the proper position.)
3) Turn clockwise the humidity control knob to the
suitable humidity(usually at normal position).
If the humidity indoor is over the set humidity,
then the machine will start removing moisture.
●
Please turn the humidity control knob to the
position of "continue" to make the machine works
continuously when exploded to a high humidity
environment.
4) When the humidity in the room reached the set humidity then the machine will
stop operating.
5) When the humidity in the room is over the set humidity then the machine will
start removing moisture again.
6) The circulation between point 3). 4). 5) is controlled by the set humidity.
● When Full Tank Lamp Is On
When the water tank is full, the indication lamp will light up,
the dehumidifier will stop operating. Remove the water in
the tank, then place the water tank back to it's proper position
the machine will start operating again.
● DEFROST
When operating in low temperatures (less than 12 ) the surface of the evaporator
will accumualate frost and effect the efficiency of the dehumidifier. When this
happens the machine will go into periodic defrost mode automatically. This is quite
normal. Defrost lamp will come on. Model (insert model no here) will operate in
temperatures down to 5 . Defrost time may vary. If the dehumidifier freezes up,
turn off at power supply and restart unit. If the temperature remains at a very low
level, continuously outside the operational range off the dehumidifier, 5
the unit should be switched off. Please contact service agents.
Remove the water in the water
tank with two hands
℃
℃
℃ ℃
to 35 ,