Personnel Qualifications; Danger In The Event Of Non-Observance Of The Safety Instructions; Safety Consciousness On The Job; Safety Instructions For The Operator - Wilo HiControl 1/FC Notice De Montage Et De Mise En Service

CAUTION!
There is a risk of damaging the product/unit. "Caution" signifies that damage to
the product and its functioning is likely if this instruction is not observed.
NOTE: Useful information on handling the product. It draws attention to possible
problems.
Information that appears directly on the product, such as
• arrows indicating the direction of rotation,
• identification for connections,
• the rating plate, and
• warning stickers
must be strictly complied with and kept in legible condition.

2.2 Personnel qualifications

The installation, operating and maintenance personnel must have the appropriate
qualifications for this work. Area of responsibility, terms of reference and moni-
toring of the personnel are to be ensured by the operator. If the personnel are not
in possession of the necessary knowledge, they must be trained and instructed.
This can be accomplished if necessary by the manufacturer of the product at the
request of the operator.

2.3 Danger in the event of non-observance of the safety instructions

Non-observance of the safety instructions may constitute a danger to persons,
the environment and the product/installation. It also results in the invalidation of
any warranty claims.
In detail, non-observance can, for example, result in the following risks:
• danger to persons due to electrical, mechanical and bacteriological influences,
• damage to the environment as a result of leakage of hazardous materials,
• damage to property,
• failure of important product/unit functions,
• failure of required maintenance and repair procedures.

2.4 Safety consciousness on the job

The existing directives for accident prevention must be adhered to.
Danger from electrical current must be eliminated. Local directives or general
directives [e.g. IEC, VDE, etc.] and instructions from local energy supply companies
must be adhered to.

2.5 Safety instructions for the operator

This device is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
device by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the device.
• If hot or cold components on the product/installation lead to hazards, then local
measures must be taken to avoid all contact.
Installation and operating instructions - Wilo-HiControl 1/FC
English
17