Maintenance And Repair; Troubleshooting - Clarke American Sanders CAV12 Manuel De L'utilisateur

ENGLISH
EN

MAINTENANCE AND REPAIR

CAUTION: Before cleaning and servicing the
machine, always remove the power cord.
Carry out only maintenance operations described in
these operating instructions. Use only original Clarke
service parts.
CAUTION: Do not make any technical
modifications to the machine. Your safety
could be endangered as a result!
For all other maintenance and repair work,
please contact and authorized service
department.
Replacing The Filter Element
1. Switch off the machine and pull the plug of the
power cord out of the plug socket.
2. Remove the machine top section from the dirt tank
and place to one side with the filter element facing
upwards (Figure 5).
3. Unscrew the filter retaining nut (1) and remove
together with the retaining washer (2).
4. Pull off the filter element (3).
5. Push on a new filter element.
6. Fit the filter retaining washer and tighten the
retaining nut.
7. Dispose of the used filter element in accordance
with the local waste disposal regulations.
Problem
Motor does not start.
Reduced suction power.
No suction power during
wet cleaning.
-6-

TROUBLESHOOTING

Cause
1. The fuse or plug socket has blown.
2. Overload protection switch has tripped.
1. Bag-type filter full.
2. Suction hose clogged.
3. Filter element clogged.
1. Tank full (float switch closing off the
suction opening).
1. Reset the fuse
2. Allow the machine to cool down approximately
5 minutes; if the machine does not start again
automatically, contact the Service Dept.
1. Replace bag-type filter.
2. Clean suction hose.
3. Clean and replace filter element.
1. Empty tank.
®
Clarke American Sanders
Figure 5
Action
Operator's Manual (EN) - CAV 12