Grounding Instructions - Clarke American Sanders CAV12 Manuel De L'utilisateur

INTRODUCTION AND INSTRUCTIONS, cont.
WARNING: Wood and varnish sanding dust could self
ignite and cause injury or damage. If these substances
have been picked up with this machine, empty immediately
after use, into a metal container.
Operation Switch
The operation switch is located on the control panel (see figure
2). To activate, turn the switch clockwise. See that the switch
is turned off before connecting or disconnecting the plug.
Removing or Securing the Head
The head is held to the tank by two clamps. Lift the clamps to
release it from the tank (see figure 3). Press in on the clamps
to secure it to the tank.

GROUNDING INSTRUCTIONS

This appliance must be grounded. If it should malfunction or
breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This appli-
ance is equipped with a cord having an equipment-grounding
conductor and grounding plug. The plug must be plugged into
an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
WARNING: Improper connection of the equipment-
grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or service
person if you are in doubt as to whether the outlet is
properly grounded. Do not modify the plug provided with
the product - if it will not fit the outlet, have a proper outlet
installed by a qualified
electrician.
This appliance is for use on a nominal 120-volt circuit and has a
ground plug that looks like the plug illustrated in figure 4. Make
sure that the appliance is connected to an outlet having the
same configuration as the plug. No adapter should be used
with this appliance.
WARNING: To prevent possible electric shock, protect the
machine from rain. Keep the machine in a dry building.
WARNING: To prevent possible electric shock, always use
a 3-wire electrical system connected to the electrical ground.
For maximum protection against electrical shock, use a
circuit that is protected by a ground fault circuit interrupter.
Consult your electrical contractor.
WARNING: Do not cut, remove or break the ground pin. If the
outlet does not fit the plug, consult your electrical contractor.
WARNING: Have worn, cut or damaged
cords replaced by an authorized service person.
EXTENSION CORDS
Use only an approved extension cord with three conductors, a
plug with three terminals, and a connector body with three
holes. The machine has a power cord with wire size 16 AWG
(AWG means American Wire Gauge).
WARNING: If you use an extension cord, use an extension
cord with minimum wire size 14 AWG. Do not use an
extension cord longer than 50 feet. Do not join two
extension cords.
®
Clarke American Sanders Operator's Manual (EN) - CAV 12
ENGLISH
Figure 2
Figure 3
Grounded
Outlet
Grounding
Pin
(A)
Figure 4
EN
Grounded
Outlet
Box
- 5 -