TIGEX Excellence 700128 Notice D'utilisation page 6

Stérilisateur electrique
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
10
Maintenance recommendations :
IMPORTANT : Always disconnect your sterilizer before cleaning it.
- Use a moist cloth to clean the control console.
- The tank, the lid and the baby bottle support can be washed in your dishwasher and also cleaned with hot soapy water.
- After the first utilization, a brownish limestone deposit caused by the heat may form on the heating plate's surface. This deposit is
not harmful, but can prevent the device from operating correctly if it stratifies.
- Avoid using anti-limestone capsules, chemical sterilizing solutions or abrasive materials to clean the device ; they could damage the
device.
TIGEX RECOMMENDS : To avoid these types of disadvantages, clean the heating surface after letting it cool off using a cloth moiste-
ned in a 30 ml solution 50 % water and 50 % white vinegar.
Warranty
Your device is covered by a 2-year warranty provided it is correctly used under the conditions indicated in the How To Use section. The
manufacturer will repair all defective parts or workmanship free of charge. Any other damage will not be warranted. Damages resul-
ting from incorrect utilization are not covered. The power cable and plug are not warranted in case they would be damaged.
As of the purchase date and for 2 years, the manufacturer will repair all recognized defects at no additional cost. This repair condi-
tion shall be covered by a previous agreement. When returning our device for repairs, always attach the warranty form (or any other
dated proof of purchase) on which the purchase date is clearly indicated. Without such proof, your device will be returned cash on
delivery (c.o.d.).
This warranty applies to all the countries where this product is sold.
In any case, the legal warranty applies in compliance with the law.
6. Reinstall the lid. Make sure the lid is properly installed.
The two arrows should be aligned.
6
7. Remove the doser integrated in the control console and fill it twice to obtain approximately 60 ml
of cold water and pour it on the steel heating base.
7
8. Carefully reinstall the tank on the base ; make sure that the tank edges fit correctly on the steel
heating base.
9. Connect the device to the wall outlet. (The device must be grounded).
8
10. Turn on the device by pressing the button to begin sterilizing.
WARNING : Be careful to avoid the hot steam that can exit through the ventilation hole on the lid.
11. The light indicator and the heating automatically turn off once sterilization is terminated after 6
minutes.
It is strongly recommended to wait a few minutes before opening the lid so that the device and its
contents can cool off. Then you can remove the baby bottles and the accessories.
IMPORTANT : Always wait for the sterilizer to cool off for at least 20 minutes before beginning a new
sterilization.
If you want to sterilize 8 standard neck baby bottles, place them directly on the tank bottom after
removing the stack plate.
4

Publicité

Table des Matières
loading

Produits Connexes pour TIGEX Excellence 700128

Table des Matières