Publicité
Les langues disponibles
Les langues disponibles
2
5
8
L6
L6
L1
L1
L2
L2
L3
L3
L5
L5
L4
L4
L6
L1
L6
L2
L3
L5
L5
L4
• The simultaneous and extended pressure on the
buttons will take you to the installer menu
L6
L1
L2
L3
L5
L4
• The buttons and allow to scroll the sym-
bols for each parameter
• The button allows to show the correspon-
4.7
ELECTRIC CONNECTIONS CONTROL UNIT
The electronic control unit of the thermal cooker
is already installed and programmed, so it is ready
for use. According to the kind of installation you
will make, it could be necessary to make further
connections to manage internal devices of the
thermal cooker.
4.8
3 WAYS VALVE CONNECTION
In some cases, it might be useful to produce sani-
tary hot water from two different generators. The
system could obtain water: from the thermal cook-
er, when it is working; from the other heat gener-
ator, when it does not work.
For this reason the installer may use a three ways
valve ruled by the control unit of the thermal cook-
4.9
CONNECTION TO ANOTHER GENERATOR
In presence of another heat generator to be man-
aged, this must be connected to the terminal
board of the control unit, directly or not directly
through an environment-thermostat. The dedi-
cated terminals are the AUX ones and they give
a clean connection, normally closed or normally
open, on choice.
To access to the terminal board of the control unit,
WARNING! Before any variation of the electric system of the thermal cooker or of the
control unit connections, the AC power connection of the device must be disabled.
2
5
8
L1
L2
L3
L4
• The buttons and allow to modify the
• The button saves the variation, the button
The additional connections may be useful and
necessary if there is another heat generator on the
same thermosanitary circuit of the thermal cooker.
In this situation, when the thermal cooker works, it
must prevail on the other generator.
er. The valve must be connected with a correct
power cable, which must be connected from the
terminal board to the control unit. The control unit
gives the power connection to the valve. The valve
may be powered in both ON and OFF conditions,
by connecting the cable correctly.
you have to unfix the front panel in which it is
fixed. The front panel cam be simply unscrewed.
Then, release the electric cables fixed inside the
technical vain with plastic clamps near the door
hinges. The clamps have to be cut.
You can now remove the front, extract the metallic
protection and then you can access directly to the
terminal board of the control unit.
126
8
L6
L1
L6
L2
L3
L5
L5
L4
L6
L1
dent value
L2
L3
L5
L4
L6
L1
L2
L3
L5
L4
indicated value
deletes the variation
L1
L2
L3
L4
Publicité
Chapitres
