Electrical Connection; Disposing Of The Packaging; Disposing Of Your Old Cooler/Freezer; Placing And Installation - Beko TSE1423N Manuel D'utilisation

Electrical connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
The connection
compliance with national regulations.
• The power plug must be easily
accessible after installation.
• Electrical safety of your cooler/
freezer shall be guaranteed only
if the earth system in your house
complies with standards.
• The voltage stated on the label
located at left inner side of your
product should be equal to your
network voltage.
• Extension cables and multi plugs
must not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Faulty product must not be operated
before it is repaired! There is the risk
of electric shock!

Disposing of the packaging

The packing materials may be
dangerous for children. Keep the
packing materials out of the reach
of children or dispose of them by
classifying them in accordance with
the waste instructions stated by your
local authorities. Do not throw away
with regular house waste, throw away
on packaging pick up spots designated
by the local authorities.
The packing of your cooler/freezer is
produced from recyclable materials.
must be in
17
Disposing of your old
cooler/freezer
Dispose of your old cooler/freezer
without giving any harm to the
environment.
• You may consult your authorized
dealer or waste collection center of
your municipality about the disposal
of your cooler/freezer.
Before disposing of your cooler/
freezer, cut out the electric plug and, if
there are any locks on the door, make
them inoperable in order to protect
children against any danger.

Placing and Installation

A
If the entrance door of the room
where the cooler/freezer will be
installed is not wide enough for the
cooler/freezer to pass through, then
carefully remove the doors of your
cooler/freezer and pass it sideways
through the door.
1. Install your cooler/freezer to a place
that allows ease of use.
2. Keep your cooler/freezer away from
heat sources, humid places and
direct sunlight.
3. There must be appropriate air
ventilation around your cooler/
freezer in order to achieve an
efficient operation. If the cooler/
freezer is to be placed in a recess in
the wall, there must be at least 5 cm
distance with the ceiling and at least
5 cm with the wall. Do not place your
product on the materials such as rug
or carpet.
4. Place your cooler/freezer on an even
floor surface to prevent jolts.
EN