Configuring The Bus Coupler - Aventics HF03 LG Série Mode D'emploi

AVENTICS | CANopen, CANopen sb | R412009415–BDL–001–AE
7.2
The configuration steps laid out in this section are
superior to the settings on the bus coupler which have
already been described (see "Making settings" on
page 82) and are a part of the entire system's bus master
configuration.
The work described here may only be carried out by
qualified electronics personnel and in compliance
with the operator's documentation on configuring
the bus master, as well as applicable technical
standards, directives, and safety regulations.
Before starting configuration, the following steps must
have been carried out and completed on the bus coupler:
W
You have assembled the bus coupler and valve
terminal (see "Assembly" on page 73).
W
You have connected the bus coupler (see "Connecting
the bus coupler electrically" on page 75).
W
You have carried out the presettings (see "Making
settings" on page 82).
Configuration error
An incorrectly configured bus coupler will lead to
malfunctions in the system and may damage the
system.
O
O
Configure the bus system in accordance with your
system requirements, the manufacturer's
specifications, and all valid technical standards,
directives, and safety regulations. Take the
operator's documentation on configuring the bus
master into account.

Configuring the bus coupler

NOTICE
The configuration may only be carried out by
qualified electronics personnel!
Commissioning and operation
89