Installing The Monitor; Monitor Operation - AEG 97153 Mode D'emploi

Installing the monitor

•
Insert the square monitor socket on the monitor
arm (10) into the designated notch at the back
of the monitor. Now slide the monitor bracket
upward until it catches (see image 12).
•
Open the locknut and adjust the monitor to the
desired viewing angle. Now tighten the locknut to
secure the monitor.
•
Clean the area of the windshield where you would
like to attach the suction cup base. Now press the
suction cup base onto the windshield and move
the locking lever toward the suction cup base.
•
Now plug the monitor cable (2) into the vehicle's
outlet (12 V). Place the monitor cable so as not to
impact or jeopardize the safety of the vehicle and
its passengers.
Locking lever
Locking screw
Image 12
Caution!
The location of the monitor may not impair the vis-
ibility of the driver! Further, do not impair the func-
tionality and operation of equipment, control units
and systems inside the vehicle. Follow applicable
laws and safety regulations for vehicles!
Monitor
swivels
Monitor
locking lever

Monitor operation

12 14 13 15
Image 13
Nr. Bezeichnung
On / Off button, lights up blue when
12
the monitor is powered on
Menu button for selecting the respective
13
adjustment mode
14 Forward / increase button
15 Back / decrease button
Guides (distance guides) on the display
16
to assist with reversing
17 Display image
Power on the monitor before using the backup
camera and off after use.
English 29
16
17