AEG 97153 Mode D'emploi page 27

Image 4
5
Image 5
If desired, you may also use caulk to seal the gasket
(8) from both sides to prevent water from entering.
Bild 6
Step 5: Mounting the license number
Now mount the plate (see image 6).
Step 6: Running the camera cable
Now run the camera cable (1) to establish a connec-
tion with the cable of the radio transmitter (11) iin
the vehicle's interior / cavity. Be sure the cables
aren't pinched or knotted. Now connect the plug
from the camera cable (1) to the socket of the
radio transmitter (11).
1 9 6
Step 7: Connecting the transmitter supply cable
Remove the cover of the reversing light. Remove
the bulb holder from the reversing light housing.
Find the vehicle supply cables to the reversing light.
Please refer to the automaker's manual.
Caution!
Disconnect the negative cable from the
vehicle's battery before working on the vehicle's
electric circuit! Stored information, codes and pro-
gramming may be lost! To prevent possible damage,
please first consult the vehicle manufacturer.
Now connect the red transmitter input lead to the
12V + (positive) cable lead of the reversing light.
Then connect the transmitter's black cable lead to
the 12V - (negative) cable lead of the reversing
light (see image 7).
Transmitter
12 V supply
cable
Camera cable
Image 7
using the two cable clamps (7) connect the cables
to the reversing light and follow the following
steps for connecting the respective cables.
Place the 12 V + (positive) reversing light cable side-
ways into the clamp connector (7) (see image 8).
English 27
+ 12 V DC
reversing light
Red
Cable
clamp
Black
Reversing
Earth
light
Camera