Temperature Setting - Ariston GL 2.5 Ti Instructions D'utilisation

CAUTION To reduce the risk of excessive pressures and temperatures in this water heater, install
the supplied temperature and pressure protective equipment required by local codes
but not less than a combination temperature and pressure relief valve certified by a
nationally recognized testing laboratory that maintains periodic inspection of
production of listed equipment or materials, as meeting the requirements for Relief
Valves and Automatic Gas Shut-off Devices for Hot Water Supply Systems, ANSI
Z21.22. The supplied temperature and pressure relief valve is marked with a maximum
set pressure (150 psi) that does not exceed the marked maximum working pressure
of the water heater. Install the valve in the opening provided and marked for this
purpose in the water heater, and orient it or provide tubing so that any discharge from
the valve will exit within 6 inches above, or at any distance below, the structural floor,
and cannot contact any live electrical part. The discharge opening must not be blocked
or reduced in size under any circumstances.
National Plumbing codes require a drain pan for any water heater installation. Failure
to install one is the sole responsibility of owner and/or installer. Reference UPC 2000
(Uniform Plumbing Code) Section 510- Protection from Damage or IPC 2000
(International Plumbing Code) Section 504- Safety Devices.
Closed
Periodic discharge of the temperature and pressure relief valve or failure of the
element gasket may be due to thermal expansion in a closed water supply system.
system
The water utility supply meter may contain a check valve, backflow preventer or water
thermal
pressure reducing valve which will create a closed water system. During the heating
expansion
cycle of the water heater, the water expands causing pressure inside the water heater
(for all
to increase. The temperature and pressure relief valve may discharge hot water under
models)
these conditions which results in a loss of energy and a build-up of lime on the relief
valve seat.
To prevent this from happening, there are two recommendations:
1. Install a diaphragm-type expansion tank that is suitable for potable water on the
2. Install a 125 PSI pressure relief valve in the cold water supply line. Make sure the
Instructions for use
Starting and
Before connecting the power, fill the tank and system with water and check for leaks. To
be certain that all air is out of the water system, open the hot water faucets on your fixtures
testing
until constant water flows from them, otherwise damage to the heating element may occur.
To start the heating cycle:
A) first make sure tank is full. Otherwise the heating element may be damaged.
B) Slide the power switch on (I). See Fig. 3/1 for power switch location.
C) The red light will come on and remain on until that temperature has been reached.
Temperature After installation check the water temperature. If adjustment is necessary, remove front
cover to adjust thermostat (D Fig. 4) clockwise to increase the temperature and
Setting
counter clockwise to decrease it.
To reach the thermostat:
1. Pry off the round cover plate (V Fig. 3/1) from its right hand edge (W Fig. 3/1) with
2. Remove the Phillips screw revealed beneath the round cover plate.
3. The cover (C Fig. 3/1) can now be removed by pulling out its left-hand edge.
cold water supply line. The expansion tank must have a minimum capacity of 1.5
U.S. gallons for every 50 gallons of stored water.
discharge of this valve is directed to an open drain and protected from freezing.
Contact the local water supplier or plumbing inspector for information on how to
control this situation. Do not plug the temperature and pressure relief valve.
The light will come back on when the water temperature drops below the
thermostat setting.
a small flat-head screwdriver.
When reassembling, work in the opposite way being careful to insert the tongue
of the cover into the slot.
5