Viking GE 345 Manuel D'utilisation page 23

Open tool compartment
1
2
The tools which are required for
assembly are in the tool
compartment.
To open the tool compartment:
Press the lid down a little with
1
one hand.
Pull the lid off with the other hand.
2
0478 215 9921 B - EN
Assembly
Assemble basic appliance
Mount the basic appliance 1 on the sup-
port foot 2 and use the Torx-spanner 19
to firstly lightly tighten the bolts 7.
Then mount the wheel axle 3 and the
limit stop 4 on the support foot 2 using
the bolts 5 and the nuts 6 (combination
spanner 17).
Now insert the wheels 8 and the plugs 9
on the wheel axle 13. Fix the plugs 9 by
hammering in the pins 10.
Next press both of the wheel caps 11 on
the wheels 8 and place the appliance on
an even floor.
Subsequently tighten the bolts 7.
(Torx-spanner 19)
Assemble funnel
Mount the funnel rubber seal 13 and the
funnel 14 on the tube 12 and fasten
these parts with the one-way bolts 15
using the screwdriver 16.
Assemble locking screw
1 Insert locking screw 20 in slot.
2
Fully screw in locking screw 20
while applying pressure.
2
1
Mount tube
Suspend and then mount the
1
tube 12 on the hinge in the
basic appliance 1.
Tighten both cover bolts
2
simultaneously.
7 7