Front Axle: Shock Tower, Control Arm, Shock Absorber - Reely ROAD Blaze Notice D'emploi

h) Front axle: shock tower, control arm, shock absorber
First install the front shock tower "A". The two shock towers are shown in
the illustration on the right. The front shock tower "A" and the rear shock
tower "B" have different shapes.
Shock tower "A" is screwed to the front differential using two tapping
screws "C" (thread length 10 mm).
Then the front control arms prepared as described in
chapter 7. c) can be installed. The following parts are
required:
2x drive shafts "D"
2x shock absorbers "E"
2x screws M3x12mm "F"
2x plastic spacers "G"
2x tapping screws 12mm "H"
2x floating wheel axles "J"
2x ball bearings "K1"
2x upper bolts "L"
2x lower bolts "M"
B
A
C
F
D
G
H
J
M
K1
E
N
L
57