Operation
6.8
Using the cooler in gas mode
➤ Turn the temperature controller (fig. 3 2, page 5) to the maximum position.
➤ Press and hold the temperature controller.
➤ After 10 seconds, press the ignition button (fig. 3 3, page 5) several times
quickly in succession until the flame is lit.
✓ After ignition, you can see the flame in the sight glass (fig. 2 6, page 4).
➤ Hold down the temperature controller for another 20 seconds.
6.9
Switching off the cooler
➤ Close off the gas valve on the device and on the gas cylinder
6.10
Defrosting the cooler
A
NOTICE!
Never use mechanical tools to remove ice or to loosen objects stuck to
the device.
I
NOTE
Over time, frost builds up on the cooling fins inside the cooler. If this
layer of frost is about 3 mm thick, you should defrost the cooler.
➤ Disconnect the voltage and gas supply.
➤ Empty the cooler.
➤ Put a cloth in the refrigerator compartment to absorb any excess water.
➤ Leave the lid open.
➤ Wipe the refrigerator compartments dry with a cloth.
22
ACX35, ACX40, ACX40G
EN