Care And Cleaning; Environment Protection - Kuppersbusch IKE 150-2 Instructions De Montage Et D'emploi

the container, which may cause it to explode,
resulting in damage to the appliance.
Ice lollies can cause frost burns if consumed
straight from the appliance.

Care and cleaning

Before maintenance, switch off the appliance and
disconnect the mains plug from the mains socket.
Do not clean the appliance with metal objects.
Do not use sharp objects to remove frost from the
appliance. Use a plastic scraper.
Regularly examine the drain in the refrigerator for
defrosted water. If necessary, clean the drain. If the
drain is blocked, water will collect in the bottom of
the appliance.
Installation
For electrical connection carefully follow the
instructions given in specific paragraphs.
Unpack the appliance and check if there are
damages on it. Do not connect the appliance if it is
damaged. Report possible damages immediately to
the place you bought it. In that case retain packing.
It is advisable to wait at least four hours before
connecting the appliance to allow the oil to flow
back in the compressor.
Adequate air circulation should be around the
appliance, lacking this leads to overheating. To
achieve sufficient ventilation follow the instructions
relevant to installation.
Wherever possible the back of the product should
be against a wall to avoid touching or catching
warm parts (compressor, condenser) to prevent
possible burn.
The appliance must not be located close to
radiators or cookers.
Make sure that the mains plug is accessible after
the installation of the appliance.
Connect to potable water supply only.
Service
Any electrical work required to do the servicing of
the appliance should be carried out by a qualified
electrician or competent person.
This product must be serviced by an authorized
Service Centre, and only genuine spare parts must
be used.
1) If the lamp cover is foreseen
2) If the appliance is Frost Free
3) If a water connection is foreseen

Environment Protection

materials. The appliance shall not be discarded
together with the urban refuse and rubbish. The
insulation foam contains flammable gases: the
appliance shall be disposed according to the
applicable regulations to obtain from your local
authorities. Avoid damaging the cooling unit,
especially at the rear near the heat exchanger. The
materials used on this appliance marked by the
symbol
3)
This appliance does not contain gasses
which could damage the ozone layer, in
either its refrigerant circuit or insulation
are recyclable.
GB
19