Service Procedures; Aligning The Cam Switch/Flush Ball - Dometic 4300 Manuel D'utilisation

Full Ceramic Gravity Discharge Toilet

7 Service Procedures


WARNING: ELECTRICAL SHOCK, FIRE,
FLOOD, AND/OR EXPLOSION HAZARD .
Failure to obey the following warnings could
result in death or serious injury:
• Use only Dometic replacement parts and
components that are specifically approved for use
with the appliance.
• This product must be installed and serviced by a
qualified service technician.
• Do not modify this product in any way. Modifi cation
can be extremely hazardous.
• Always disconnect the unit from power before
servicing. Confirm that all electrical power to the unit
has been turned off, and for marine applications,
ensure that seacocks are in the closed or off position.
This section has information to help you service the unit
components, if needed. These service procedures are
intended for emergency purposes. Contact "Customer
Support" on page 28.
7 .1 Aligning the Cam Switch/Flush
Ball
A
7 Correct Cam Switch/Flush Ball Alignment
Flush Ball
q
The flush ball should be properly positioned so that the
"A" and "B" distances are equal (see Figure 7).
If the flush ball becomes misaligned, water can leak from
the bowl or other flushing problems will occur.
EN
B
q
To resolve these problems, perform the following
actions as applicable to the over-travel or under-travel
condition of the cam switch/flush ball alignment.
8 Over-Travel Condition and Fix
9 Under-Travel Condition and Fix
Flush Ball
q
1. Turn off water and electrical power to the toilet.
2. Disconnect the water line.
3. Remove the toilet from the floor. Refer to section "7.2
Removing the Toilet from the Floor" on page 12.
4. Loosen the cam switch mounting screws using a
3/32 in. (0.25 mm) hex tool and a 1/4 in. (6 mm)
box-end wrench.
Troubleshooting
q
w
q
w
Cam Switch
w
11