Technical Specification - Lanaform Trainy Mode D'emploi

Strange-smelling vapour
EN
Low intensity
The vapour is not rising
Noise

TECHNICAL SPECIFICATION

• Maximum evaporation rate: 200 ml/h
• Capacity of the water tank: 1.8 L
• Noise: ≤ 35dB
ADVICE REGARDING THE DISPOSAL OF WASTE
• All the packaging is composed of materials that pose no hazard for the environment and which can be disposed of at
your local sorting centre to be used as secondary raw materials. The cardboard may be disposed of in a paper recycling
bin. The packaging film must be taken to your local sorting and recycling centre.
• When you have finished using the device, please dispose of it in an environmentally friendly way and in accordance with
the law.
LIMITED WARRANTY
LANAFORM® guarantees this product against any material or manufacturing defect for a period of two years from the
date of purchase, except in the circumstances described below.
The LANAFORM® guarantee does not cover damage caused as a result of normal wear to this product. In addition, the
guarantee covering this LANAFORM® product does not cover damage caused by abusive or inappropriate or incorrect use,
accidents, the use of unauthorized accessories, changes made to the product or any other circumstance, of whatever sort,
that is outside LANAFORM®'s control.
LANAFORM® may not be held liable for any type of circumstantial, indirect or specific damage.
All implicit guarantees relating to the suitability of the product are limited to a period of two years from the initial date of
purchase as long as a copy of the proof of purchase can be supplied.
8
The water has been in the tank too
long.
Essential oil.
The vapour intensity control is at
minimum
Sediment on the transducer.
The water is too cold.
The water is unclean.
The vapour intensity control is at
minimum
The tank and the base are not
connected properly
The fan is not working correctly
Resonance due to the water level in
the tank being too low
Resonance due to an unstable surface Place the unit on a stable surface
Clean the tank and fill with fresh
water.
Replace the cotton used for the
essential oil.
Adjust the control button
Clean the transducer.
Use water at room temperature.
Clean the tank and fill with fresh
water.
Adjust the vapour intensity
Check that they are connected
properly
Return appliance to supplier or after-
sales department.
Add water to the tank.