Makita DRT50 Manuel D'instruction page 11

1
► 1 . Lock lever
6. Mount the belt to the pulley by rotating the belt
manually.
► 1 . Pulley 2. Belt
7. Close the lock lever.
► 1 . Lock lever
8. Attach the base plate by tightening the screws.
► 1 . Base plate
9. Insert the collet cone and the trimmer bit into the
offset base, and then tighten the collet nut.
1
1
2
2
3
► 1 . Trimmer bit 2. Collet nut 3. Collet cone
10. Insert the hex wrench into the hole of the offset
base, and then tighten the collet nut with the wrench.
1
► 1 . Collet nut 2. Wrench 3. Hex wrench
To remove the base, follow the installation procedure
in reverse.
NOTE: You can also mount the belt to the pulley with-
out removing the base plate as shown in the figure.
11 ENGLISH
1
1
2
3