Installation On Support Structure; Recessed Hole - CAN FC Série Manuel D'instructions

GAS HOB UNITS WITH GLASS RECESSED LID ▪

INSTALLATION ON SUPPORT STRUCTURE

The appliance must be mounted on a support structure, made of material fire-retardant and resistant to
heat and with all of the sturdiness requirements indicated by the technical sector standards (for example
EN14749). The work table must be perfectly horizontal and perpendicular to all surrounding vertical panelling.
The area near the appliance could get very hot. Pay the utmost attention and do not place sockets, other
household appliances, power cables, piping and any other heat-sensitive or flammable material in this area.
ATTENTION!
The appliance must be installed in a room without air draughts which can have a negative
effect on combustion. The chosen installation position must also prevent the accumulation of
unburnt gases.
Comply with the sizes indicated in this manual. Any deviation could cause the temperature to rise excessively.
The surrounding surfaces must be able to withstand temperature rises admitted by standard EN30-1-1 and in
compliance with the design of this unit. All combustible material, such as curtains and shelves, must be kept
far away from the appliance. Check the admissible temperature of the materials used for the surrounding
surfaces to guarantee their compliance with the requirements of EN30-1-1.

RECESSED HOLE

The support structure must be provided with a suitable recessed hole. For information regarding the
dimensions of the hole of your model, refer to the table below and follow the drawings in the technical data
sheets of each model in the first section of this manual.
model
FC1336
FC1337
FC1343
FC1344
FC1345
FC1347
FC1348
FC1349
FC1350
FC1352
Refer to the drawings in the TECHNICAL DATA SHEETS for the recessing details of each model.
94
recessed hole sizes
[mm] [mm]
a b
530 340
340 530
480 480
480 480
- -
440 440
510 390
716 340
716 340
748 310
FC series
Ø
[mm]
-
-
-
-
340
-
-
-
-
-