Safety; Symbols; General Instructions - Nilfisk BA 410 Manuel D'utilisation

ENGLISH

SAFETY

The following symbols indicate potentially dangerous situations. Always read this information carefully and take all necessary
precautions to safeguard people and property.
The operator's cooperation is essential in order to prevent injury. No accident prevention program is effective without the total
cooperation of the person responsible for the machine operation. Most of the accidents that may occur in a factory, while working
or moving around, are caused by failure to comply with the simplest rules for exercising prudence. A careful and prudent operator is
the best guarantee against accidents and is essential for successful completion of any prevention program.

SYMBOLS

DANGER!
It indicates a dangerous situation with risk of death for the operator.
WARNING!
It indicates a potential risk of injury for people.
CAUTION!
It indicates a caution or a remark related to important or useful functions.
Pay careful attention to the paragraphs marked by this symbol.
NOTE
It indicates a remark related to important or useful functions.
CONSULTATION
It indicates the necessity to refer to the User Manual before performing any procedure.

GENERAL INSTRUCTIONS

Specifi c warnings and cautions to inform about potential damages to people and machine are shown below.
DANGER!
– Disconnect the batteries before performing any maintenance/repair procedure.
– This machine must be used by properly trained and authorised personnel only. Children or disabled people
cannot use this machine.
– When using lead (WET) batteries, keep sparks, fl ames and smoking materials away from the batteries.
During the normal operation explosive gases are released.
– Do not wear jewels when working near electrical components.
– Do not operate the machine near toxic, dangerous, fl ammable and/or explosive powders, liquids or
vapours.
– When using lead (WET) batteries, battery charging produces highly explosive hydrogen gas. During battery
charging, remove the recovery water tank and perform this procedure in well-ventilated areas and away
from naked fl ames.
4
USER MANUAL
909 5683 000(2)2007-06 A BA 410