Wash Temperature; How To Use Your Washer - Danby DWM99W Manuel D'utilisation

WASH TEMPERATURE

Hot Water
Hot water will give the best results of cleaning and
sanitizing. But it is not suitable for all articles. It is
best for sturdy whites and colourfast articles, heavily
soiled articles and diapers.
Warm Water
By using warm water, there is less chance of colour
loss in articles. Use with light and moderate soils,
non-colourfast or dark colours, permanent press,
silks, woolens, nylons and acrylic.
A.) Determine proper cycle
• Press down the program knob and turn it to the
desired function.
• Pull up the program knob to start the wash
program.
WARNING:
The program knob can only be turned clockwise
when it is pressed down.
B.) To Wash clothes
IMPORTANT:
Before using your new washer, make sure the
washer cord is plugged into a properly grounded
and polarized outlet which has the appropriate volt-
age (refer to the serial plate). Make sure the washer
hoses are connected to the hot and cold water
faucets, and that the faucets are turned on. Be sure
the drain hose is not kinked and is inserted into a
drain. See the INSTALLATION INSTRUCTIONS for
details of proper washer installation.
Before using the washer for the first time, wipe out
the inside of the washtub with a sudsy cloth.
1. Load laundry and add detergent (refer to
section "GENERAL WASHING INFORMATION"
for proper detergent usage.
2. Water level, Select water level according to
laundry quantity. Refill function allows you to
add water during operation (turn the water
level knob to RESET and hold for 2-3 seconds.
Then turn to the level desired).
Cold Water
Cold water is less effective in cleaning than hot or
warm water, but it does minimize wrinkling and
colour fading. Use it for washing extra sensitive
clothes and for the rinsing of all fabrics.
Energy
You can save energy when washing by following a
few guidelines:
1. Heating water accounts for the greatest
2. Wash full loads, but do not overload.
3. Select a shorter wash time for lightly soiled

HOW TO USE YOUR WASHER

3. Wash Choice,
4. Close the lid
5. Set WASH/RINSE temperatures
C.) Timer
Although the washer cycles are automatic, the timer
may be reset to lengthen, shorten or repeat a por-
tion of the cycle.
To set or reset the timer, push timer knob in to stop
the washer. Hold timer knob firmly while turning
clockwise to the setting desired. Pull timer knob out
to start the washer.
14
expense when washing. Save on heating water
by using cold rinses.
articles.
regular mode, press down the WASH CHOICE
button. Gentle mode, release the button.
The washer will not spin with the lid open.
NOTE: If your washer is (permanently installed
connected to both a HOT/COLD water supply,
the washer will provide a cold rinse in all
temperature settings. If your washer is installed
under a portable application, connected to a
single water supply, the wash and rinse
temperatures will be the same. Also refer to
the "special note" under portable (single
hose) installation.