Faber INCA PRO PLUS INPL3019SSNB-B Instructions D'installation page 11

INSTALLATION WITH REMOTE BLOWER (RB900 / RB1200) OR IN-LINE BLOWER (INLBKIT)
NOTE: FOLLOW THE INSTRUCTIONS INCLUDED WITH THE REMOTE BLOWER TO
INSTALL THE BLOWER ON THE OUTSIDE OF YOUR HOME.
OR IN-LINE BLOWER (INLBKIT)
1. Install the Plate B with the second wiring box
(Figure 13) which came with the remote blower kit,
on top of the rangehood. Use 9 screws supplied with
the blower kit. Remove the electrical knockout hole
on top of the plate.
FIGURE 21
OR IN-LINE BLOWER (INLBKIT)
FIGURE 13
FIGURE 22
2. Remove the white plastic covering and Install the
4 side trim pieces (4-5) to the outside of the hood
using (14) part 9c screws, see the side rail installation
in (Figure 14).
9c
FIGURE 23
5
4
FIGURE 14
B
2 wiring box
nd
6 hole end
2 wiring box
nd
B
4
3. Connect the wire coming out from the 2
to the 6 hole end of the 1
Connect the wire that comes out from the black box of
the electronic board to the 9 hole end of the 1
box (Figure 15).
1
st
FIGURE 24
4. Feed the remote blower cable thru the knockout hole in step 1
(FIGURE 24). Connect the power supply cable from the remote
blower to the wiring box on the top ducting plate of the hood. Use
step 6 on page 8 and the diagram on page 8 (FIGURE 13)
5. Attach the hood to the cabinet using (12) 9c. screws to the
cabinet. FIGURE 25
FIGURE 15
6. Follow steps 6 - 9 on page 8 to connect ducting, wiring, and
test the electrical connection. Use the wiring box connected to
the inside wall of the hood which connects to the home power
supply thru the knockout on the side of the hood.
4. Pass the remote blower cable through the
knockout hole in step 1 (Figure 13,16). Connect this
cable from the remote blower to the 2
placed on the lower surface of plate B.
FIGURE 16
FIGURE 24
4. Feed the remote blower cable thru the knockout hole in step 1
(FIGURE 24). Connect the power supply cable from the remote
blower to the wiring box on the top ducting plate of the hood. Use
step 6 on page 8 and the diagram on page 8 (FIGURE 13)
5. Follow step 4 on page 13 to connect ducting,
5. Attach the hood to the cabinet using (12) 9c. screws to the
cabinet. FIGURE 25 wiring, and test the electrical connection. Use the
FIGURE 25
wiring box connected to the inside wall of the hood
6. Follow steps 6 - 9 on page 8 to connect ducting, wiring, and
which connects to the home power supply thru the
test the electrical connection. Use the wiring box connected to
the inside wall of the hood which connects to the home power knockout on the side of the hood.
supply thru the knockout on the side of the hood.
5
wiring box.
st
wiring box
6 hole end
Version 07/11 - Page 10
wiring box
nd
wiring
st
wiring box
nd
11