Familiarisez-Vous Avez Votre Aspirateur Lightweight Heavyweight; Spécifications Techniques - shark EP621 Guide Du Propriétaire

FAMILIARISEZ-VOUS AVEZ VOTRE ASPIRATEUR
LIGHTWEIGHT HEAVYWEIGHT
1. Poignée
2. Porte boyau/cordon
3. Boyau souple
4. Manche de boyau amovible
5. Couvercle du filtre
d'échappement
6. Corps de l'appareil
7. Coupelle à poussière
8. Levier de relâche de la
coupelle
9. Tube de rallonge
10. Commutateur
11. Poignée à soulever
12. Suceur plat
13. Brosse à épousseter
14. Brosse à planchers
motorisée
15. Crochet de cordon à
relâche rapide
16. Crochet de cordon inférieur
17. Porte boyau inférieur
18. Boyau d'entrée
19. Cordon d'alimentation
20. Voyant d'avertissement
pour brosse rotative
21. Commande manuelle de
succion variable
22. Bouton d'ouverture de la
trappe
23. Surveille-filtre Intelli-
Sense mc
24. Bague pour Boyau
Spécifications techniques
Tension : 120V., 60Hz.
Puissance : 12 amp
24
OPERATING INSTRUCTIONS
Changing the Belt
WARNING:
Always disconnect
from power source when servicing
or cleaning the unit. Failure to do so
could result in electrical shock or
personal injury from cleaner suddenly
starting.
Occasionally the motorized brush drive
belt will require changing, the frequency
will depend upon the amount of use your
vacuum sees.
• Turn unit "Off" and unplug from
wall outlet.
• Remove the motorized floor brush
from the main unit.
• Use a Phillips #1 screwdriver and
remove the two (2) front screws
from the bottom of the motorized
floor brush. (Fig. 18)
Screws
Fig. 18
• Remove the brush cover. (Fig. 19)
Fig. 19
Fig. 20
• Remove the brush carefully by first
lifting the right side of the brush and
then the left side of the brush. Be
careful not to lose the end caps and
washers (x2). (Fig. 18)
• If the belt has broken, remove any
loose pieces of broken belt before
replacing with new belt.
• To stall a new belt, slip one end of
the belt over the gears on the motor
shaft and then slip the other end
over the pulley end of the brush.
• After checking that the end caps
and washers are on correctly,
• re-install the brush assembly.
• Turn the brush assembly by hand to
make sure that the belt is not
twisted and all rotating parts turn
freely.
• Replace the brush cover and
screws. (Fig. 21)
Fig. 21
Motor Thermostat
IMPORTANT:
This unit is equipped
with a motor protective thermostat. If
for some reason the vacuum cleaner
should overheat, the thermostat will
automatically turn the unit off. Should
this occur:
• Push the On/Off button once.
• Disconnect the plug from the power
source.
• Check the source of overheating
problem. (i.e. clogged hose or filter)
• If clogged hose or filter is found,
unclog the hose and replace the
filters.
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for 45
minutes, plug in the cleaner and
push the On/Off button. The
vacuum should start again.
• If the vacuum still does not start,
contact customer service at
1 (800) 798-7398.
9