Installation; Opening The Siren; Fixing The Bottom To The Wall - Elkron HPA800 Notice D'installation

2.0 INSTALLATION

2.1 OPENING THE SIREN

2.2 FIXING THE BOTTOM TO THE WALL

The siren must be appropriately fixed to a solid wall and
well anchored using dowels of the type suited for the
installation support (T1-T4, not supplied).
WARNING! The anchor bolt (TA) must be
fixed for the correct operation of the anti-
removal tamper function.
Use the access points provided (IC1-IC3) to pass through
the wires.
Insert the battery (BA) into the housing behind the siren
board, as shown in the figure.
To open the cover, simply undo the screw (A) on the underside of the
cover by about 5 mm; it is not necessary to remove the screw.
Move the bottom of the cover away from the bottom by slightly rotating it
on the top and then moving it upwards.
27/52
HPA800