Display Mode - Cardin Elettronica GL Série Mode D'emploi

DISPLAY MODE

Using the PROG button you can access the following functions in sequence:
- memorising the status of the dip-switches;
- display the status of the command and safety devices;
- display the number of manoeuvres;
test
- enabling/disabling automatic reclosing in the presence of an obstacle;
- setting the current sensor level;
- setting the distance from the opening direction travel limit (indicative values).
The status of the security devices
are always shown on the display.
Memorising the DIP-SWITCH
displaying the firmware version (e.g. "14")
The segments regarding the command status (LED
"ON" command active) and safety status (LED
rest) light up.
The number of manoeuvres appears on the display.
This number always remains visible until you change
the setting. Once 999999 has been exceeded the
lighting up of the decimal point on the display
equals 1 million + the six figure number.
In the mode (only activated when the motor
has stopped) it is possible to check the status of the
command and safety devices. The warning lights
will activate once, each time a "TD-TB-FTCI"
command is received. In this mode you can activate
serial line communication by using the external
program, which is to be connected to the CSER
connection via cable (fig. 13). While communication
is active dashes will appear on the display; after 5
seconds of inactivity you will be moved back to the
To return to the normal operating mode
press the button again "test" will appear, then wait
for 10 seconds.
drA
Setting the reclosing function
with an obstacle:
ogrammer tries to close three times.
ogrammer tries to close once
PREMERE
10 sec
PROG
10 seconds after the last
modification the program
will save the chosen value
(e.g. "0" and exit
automatically
dSt om the opening
direction travel limit (approximate values)
- "0 0 centimeters - "1 1 centimeter
- "2 2 centimeters - "3 3 centimeters
TB FTCI
and
PRESS PROG
settings and
PRESS PROG
PRESS PROG
PRESS PROG
10 sec
Each time the
PROG button is
pressed the selection
PRESS
alternates between
PROG
"1" and "0".
PRESS
PROG
Each time PROG
pressed the number will
increase (from 0 to 3).
PRESS PROG
10 s after the last modification you
will be automatically moved out of
the mode and the selected values
will be saved (eg. 1)
10 sec
10 sec
5 sec
Connect the
programming device
(CSER) and activate it.
10 sec
PRESS
PROG
pressed the number will
increase (from 1 to 3).
10 sec
24
TD-TB-FTCI e activated
the warning and courtesy lights will light up.
PRESS PROG
SNS Setting the current sensor.
10 sec
PRESS PROG
10 s after the last modification you
will be automatically moved out of
the mode and the selected values
will be saved (eg. 3)
10 sec
10 sec