Cleaning And Maintenance; Defects And Malfunctions; Transport And Storage; Additional Information - Tunturi E-80R Recumbent Bike Manuel De L'utilisateur

Cleaning and maintenance

The equipment does not require special maintenance. The equipment
does not require recalibration when it is assembled, used and serviced
according to the instructions.
⚠ WARNING
• Do not use solvents to clean the equipment.
- Clean the equipment with a soft, absorbent cloth after each use.
- Regularly check that all screws and nuts
are tight.
- If necessary, lubricate the joints.

Defects and malfunctions

Despite continuous quality control, defects and malfunctions caused
by individual parts can occur in the equipment. In most cases, it will be
sufficient to replace the defective part.
- If the equipment does not function properly, immediately contact the
dealer.
- Provide the model number and the serial number of the equipment
to the dealer. State the nature of the problem, conditions of use and
purchase date.
Trouble shooting:
- When the display of LCD is dim, it means the batteries need to be
changed.
- If there is no signal when you pedal, please check if the cable is well
connected.
‼ NOTE
• When stop training for 4 minutes, the main screen will be off.
• If the computer displays abnormally, please re-install the batteries
and try again.
Squeaking rollers
- Regular Usage: Apply 2cc. of the lubricant on each protruding rail
surface every three months.
- When sliding wheels are making noise during sliding movement,
apply 2cc. of lubricant on each protruding rail surface immediately.
⚠ CAUTION
• We recommend to use a silicon based lubricant.
• Do not apply too much lubricant or wipe off redundant lubricant
with a clean cloth as too much lubricant can cause carpet stain or
dirt particle.
Shaky or unstable feeling during use
If the machine feels unstable or unstable during operation, it is
advisable to adjust the support feet to bring the frame to the correct
height. Read the instructions in this manual in section: "Use"

Transport and storage

⚠ WARNING
• Carry and move the equipment with at least two persons.
- Remain standing in front of the equipment on each side and take a
sturdy grip at the handlebars. Tilt the front of the equipment so as
to lift the rear of the equipment on the wheels. Move the equipment
and carefully put the equipment down. Place the equipment on a
protective base to prevent damage to the floor surface.
- Move the equipment carefully over uneven surfaces. Do not move the
equipment upstairs using the wheels, but carry the equipment by the
handlebars.
- Store the equipment in a dry place with as little temperature variation
as possible.

Additional information

Packaging disposal
Government guidelines ask that we reduce the amount of waste
material disposed of in land fill sites. We therefore ask that you dispose
of all packaging waste responsibly at public recycling centres.
End of life disposal
We at Tunturi hope you enjoy many years of enjoyable use from your
fitness trainer. However, a time will come when your fitness trainer will
come to the end of its useful life. Under 'European WEEE Legislation
you are responsible for the appropriate disposal of your fitness trainer
to a recognised public collection facility.

Technical data

Parameter
Telemetric heart rate
receiver
Length
Width
Height
Weight
Max. user weight
Adapter
Voltage
Current

Warranty

Tunturi purchaser's warranty
Warranty terms
The consumer is entitled to the applicable legal rights stated in the
national legislation concerning the commerce of consumer goods.
This warranty does not restrict these rights. The Purchaser's Warranty
is only valid if the item is used in an environment approved by Tunturi
New Fitness BV for that particular equipment. The product-specific
approved environment is stated in the Owner's Manual provided with
your equipment.
Warranty conditions
The warranty conditions commence from the date of purchase. Warranty
conditions may vary per country, so please consult your local dealer for
the warranty conditions.
Warranty coverage
2 7
Unit of Value
measurement
Frequency 5.0 Khz
cm 171
Inch 67
cm 64
inch 25
cm 121
inch 48
kg 62.1
lbs 136.6
kg 135
lbs 300
V 26V-DC
Ma. 2.3 A
English