OK. OTG 100 Mode D'emploi page 17

Size - A5
• C leaning and user maintenance shall not
be made by children unless they are older
than 8 and supervised.
• K eep this product and its power cord out
of reach of children under the age of 8.
• W arning! Charcoal or similar combustible
fuels must not be used with this product.
• A damaged power cord may only be
replaced by the authorised service agent
in order to avoid hazards.
• Read this user manual thoroughly before first use and pass it on with the product.
Pay attention to the warnings on the product and in this user manual. It contains
important information for your safety as well as for the use and maintenance of the
equipment.
• Use the product only for its intended purpose and with recommended accessories
and components. Improper use or wrong operation may lead to hazards.
• Never leave the product unsupervised while it is switched on.
• Do not place heavy objects on top of the product.
• Never immerse electrical parts of the product in water during cleaning or operation.
Never hold the product under running water.
• Do not under any circumstances attempt (e.g. damage in power cord, product
is dropped, etc.) to repair the product yourself. For servicing and repairs, please
consult an authorised service agent.
• The mains voltage must match the information on the rating label of the product.
• Only unplug from the power socket can separate the product completely from the
mains. Please be sure that the power plug is in operable condition.
• Avoid damages to the power cord that may be caused by kinks or contact with
sharp corners.
• Keep this product including power cord and power plug away from all heat sources
like for example, ovens, hot plates and other heat-producing products/objects.
• Only unplug from the power socket by the plug itself. Do not pull on the cord.
• Unplug the product ...
- when the product is not being used,
- in case of malfunctions,
- before attaching / detaching accessories and
- before cleaning the product.
OTG100_A5_131108.indb 17
17
8/11/13 10:09 AM