Trim Installation - Cooper Lighting Solutions LSRWM8B Instructions D'installation

Installation Instructions – LSRWM8BX* Commercial LED Rough-In
INSTALLATION
LED and Trim assembly to be installed only after
N otee:
cylinder is installed.
Wall Mount Section
1. Install wall mounting plate to splice box using splice
box hardware (provided by others) and tighten to 17 IN/
LBS torque when using 8-32 screw (Figure 1).
2. Wire unit per appropriate Wiring Diagram (refer to
electrical section).
3. Attach rear wall mount tether to splice box mounting
screw.
4. Mount cylinder housing assembly to wall by tightening
screws on top and bottom of arm base to 17 IN/LBS
torque to engage mounting plate.
5. Installer must apply silicone compound around entire
perimeter of the mounting arm where it mates to the
mounting surface.

Trim Installation

1. Remove reflector from protective packaging. Remove
plastic trim ring and discard. Remove LED engine from
protective packaging (Figure 2). Rotate sideclips (3)
outwards (Figure 3)
2. Place LED Engine onto Lower trim. Align post on
LED Engine with slot on trim assembly (Figure 4).
Figure 1.
LED Engine
Lens
Lower Trim
Figure 2.
Lower Trim Assembly
2
COOPER LIGHTING SOLUTIONS
Torsion
Springs
IL520015ML Installation instructions
Figure 3.
Figure 4.
Figure 5.
Figure 6.
Side
Clips