Gaggenau BSP 250 610 Notice De Montage page 5

Before you begin
Tools and parts needed
▯
Philips head screwdriver
▯
1/8" drill bit and drill
▯
Measuring tape
Parts included
▯
Combi-steam oven
▯
3 Torx screws
Power Requirements
The outlet must be properly grounded in accordance
with all applicable codes.
Planning notes
Door hinge not interchangeable.
Distance from furniture body to door front 1.85"
(47 mm).
Distance from furniture body to outer edge of door
handle 3.7" (94 mm) after retrofitting the handle (special
accessory).
Pay attention to the front protrusion, possibly including
the door handle, for opening drawers at the sides.
When planning a corner solution, pay attention to the
door opening angle of at least 90°.
B e f o r e y o u b e g i n
Preparing Kitchen Units
Units into which ovens are to be fitted must be heat-
resistant up to 195°F (90°C) and adjacent cabinets up
to 160°F (70°C).
Connection box must be outside of the installation
niche.
Perform cut-out work on the furniture before inserting
the appliance. Remove any shavings or the function of
the electrical components may be impaired.
Secure freestanding units to the wall using a standard
bracket.
Only fit the appliance up to a height that allows
accessories to be removed easily.
P r e p a r i n g K i t c h e n U n i t s
5