Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
OPTIONAL ACCESSORIES
Sequential Trip Mechanism Kit (Code No. 878226)
(Single Shot Parts)
Pneumatic Tool Lubricant
1 oz. (30 cc) oil feeder
4 oz. (120 cc) oil feeder
1 quart (1 ltr) can
NOTE: Accessories are subject to change without any
obligation on the part of HITACHI.
APPLICATIONS
Installation of asphalt roofing shingles in building
contrcution.
Installation of insulation boards in building
construction.
BEFORE OPERATION
Read section titled "SAFETY" (pages 4 – 7).
Make sure of the followings before operation.
WORKING ENVIRONMENT
WARNING
No flammable gas, liquid or other flammable
objects at worksite.
Clear the area of children or unauthorized
personnel.
AIR SUPPLY
WARNING
Never connect Nailer to pressure which
potentially exceeds 200 psi (13.7 bar 14 kgf/cm
Never use non relieving coupler on Nailer.
1. Power source
Use only clean, dry, regulated compressed air as a
power source for this Nailer.
Air compressors used to supply compressed air to this
Nailer must comply with the requirements of the latest
version of ANSI Standard B 19.3 "Safety Standard For
Compressors For Process Industries."
... sold separately
(Code No. 877153)
(Code No. 874042)
(Code No. 876212)
DANGER
NEVER use oxygen or
other bottled gases.
Explosion may occur.
Moisture or oil in the air compressor may accelerate
wear and corrosion in the Nailer.
Drain daily.
2. Filter-Regulator-Lubricator
Use a regulator with a pressure range of 0 – 120 psi
(0 – 8.3 bar 0 – 8.5 kgf/cm
Filter-regulator-lubricator units supply an optimum
condition for the Nailer and extend the Nailer life.
These units should always be used.
Filter ............. The filter removes moisture and dirt
Regulator ..... The regulator controls the operating
Lubricator .... The lubricator supplies an oil mist to the
Nailer Side
3. Air hose
Air hose must have a minimum working pressure
rating of 150 psi (10.4 bar 10.6 kgf/cm
maximum pressure produced in the system,
whichever is higher.
4. Hose coupling
The Nailer can be installed as follows:
Remove the dust cap placed at the air inlet.
Install a 3/8 NPT male plug at the air inlet.
2
).
A female coupler must be on the air hose.
The hose coupling (male plug-female coupler) must
remove all pressure from the Nailer when
disconnected.
Never use a non relieving coupler on the Nailer.
— 10 —
2
).
mixed in compressed air.
Drain daily unless fitted with an
automatic drain.
Keep the filter clean by regular
maintenance.
pressure for safe operation of the Nailer.
Inspect the regulator before operation to
be sure it operates properly.
Nailer.
Inspect the lubricator before operation
to be sure the supply of lubricant is
adequate.
Use Hitachi pneumatic tool lubricant.
Regulator
Compressor Side
Filter
Lubricator
2
) or 150% of the
Dust Cap
3/8 NPT Male Plug
Publicité
Table des Matières
