Micromaxx MD 15442 Mode D'emploi page 40

6.5.2. Mode 2 (Charging process for 6 V battery, receiver
battery capacity 1.2–120 Ah, 4 A charging current)
Set this mode to quickly charge 6 V lead acid batteries with a capacity under 120 Ah.
The charger normally recognises the mode suitable for the battery type. If the bat-
tery is still not detected, do the following:
NOTE
Refer to the nameplate on your battery for the battery type.
 Press the MODE button several times to select Mode 2.
Charging mode 2
If you then do not set another mode the electronics automatically start the charg-
ing process with a charging current of around 4 A.
When the battery is fully charged, all bars on the battery display are permanently lit.
Trickle charging takes place in this status.
6.5.3. Mode 3 (Charging process for 12 V motorcycle battery
or 12 V car battery, receiver battery capacity 1.2–120
Ah, 1 A charging current)
Set this mode to charge batteries with a capacity under 120 Ah.
The charger normally recognises the mode suitable for the battery type. If the bat-
tery is still not detected, do the following:
NOTE
Refer to the nameplate on your battery for the battery type.
 Press the MODE button several times to select Mode 3.
Charging mode 3
If you then do not set another mode the electronics automatically start the charg-
ing process with a charging current of around 1 A.
When the battery is fully charged, all bars on the battery display are permanently lit.
Trickle charging takes place in this status.
40 of 95
is shown on the screen.
is shown on the screen.