Warranty - Redstone RS 613 B Notice Originale

should be performed by certified service centres
or other qualified service organisations, always
using genuine replacement parts.
BUILT-IN DUST PROTECTION
The protective ring 1 preserves the tool socket
from dirt during operation. While inserting the
tool, take care that you do not damage the pro-
tective ring.
WARNING: Replace a damaged pro-
tective ring immediately!
To replace the protective ring 1, pull back the
locking socket 2. Grasp the protective ring and
pull it strongly slantwise forward. Place a new
protective ring onto the spindle and press it
hard.
INDICATION "SERVICE MAINTE-
NANCE"
When the red light-emitting diode begins to blink
while the machine operates normally, replace-
ment of the brushes is needed. After approxi-
mately 8h operation, the brushes are worn out
completely and the safety switch actuates. The
machine halts and the red light-emitting diode
keeps blinking. Deliver the machine to an au-
thorised service for repla cement of brushes and
preventive main tenance.
If the machine does not operate before the
warning period of 8 hours is over, and the red
light-emitting diode blinks, that probably means
the motor is damaged. In case there is no light
indication and the machine does not operate,
that means there is no power supply to the ma-
chine or that the automatic switch or the cord
are faulty.
PREVENTIVE MAITENANCE
This power tool shall be submitted periodically
to REDSTONE authorised service centre for
preventive maintenance. Preventive checks will
boost the life of your power tool.
First check - after approximately 70 h ope-
ration.
The functioning of the machine shall be evalu-
ated and if necessary the machine shall be
checked.
Second check - after approximately 140 h
operation or upon the event of brushes wearing
out.
Original instructions
The machine shall be cleaned thoroughly and
checked. Ascertained or potential faults shall be
eliminated (brushes and O-ring sealings shall be
replaced).
Third check - after approximately 250 h oper-
ation or upon the event of brushes wearing out.
The machine shall be cleaned thoroughly and
checked. Ascertained or potential faults shall be
eliminated (brushes and O-ring sealings shall be
replaced).
Fourth check - after approximately 350 h ope-
ration or upon the event of brushes wearing
out.
The machine shall be cleaned thoroughly and
checked. Ascertained or potential faults shall be
eliminated (brushes and O-ring sealing shall be
replaced).

Warranty

The guarantee period for REDSTONE power
tools is determined in the guarantee card.
Faults due to normal wear, overloading or im-
proper handling will be excluded from the guar-
antee.
Faults due to defective materials implemented
as well as defects in workmanship will be cor-
rected free of charge through replacement or
repair.
The complaints for defective REDSTONE power
tools will be recognized if the machine is sent
back to the dealer or is presented to the author-
ised warranty service centre undismantled, in its
initial condition.
Notes
Carefully read the entire Instruction Manual be-
fore using this product.
The manufacturer reserves the right to make
changes and improvements to the products and
to alter specifications without prior notice.
Specifications may differ from country to coun-
try.
17
EN