Important Safety Instructions - AEG 3500 Notice D'utilisation

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic safety precautions should always
be followed, including the following:
Read all instructions before using your household sewing machine.
DANGER-To reduce the risk of electric shock:
Your household sewing machine should never be left unattended when
plugged in. Always unplug your machine from the electric outlet immediately
after using and before cleaning.
Change the light bulb only with the same type of bulb. Use a bulb 15W.
WARNING-to reduce: the risk of burns, fire, electric shock or injury to
persons
- Do not allow to be used as a toy. Close attention is necessary when this
sewing machine is used by or near children.
- Use this machine only for its intended use as described in this manual.
- Never operate this sewing machine if it has a damaged cord or plug, if it is
not working properly, if it has been dropped or damaged or dropped into
water. Return the sewing machine to the nearest authorized dealer or
service center for examination, repair, electrical or mechanical adjustment.
- The supply cord cannot be replaced. If the supply cord connected with foot
controller is damaged the foot controller shall be scrapped.
- Never operate the sewing machine with any air openings blocked. Keep
ventilation openings of the sewing machine and foot controller free from the
accumulation of lint, dust and cloth.
- Never drop or insert any object into the opening.
- Do not use outdoors.
- Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
- Do not put anything on the foot controller because the machine may
accidentally start and the motor or the foot controller may overheat.
- To disconnect turn all controls to the off position, then remove plug from
outlet.
- Do not unplug by pulling on cord. To unplug, hold the plug, not the cord.
- Keep fingers away from all moving parts. Special care is required around
the sewing needle.
- Always use the proper needle plate. The wrong plate can cause the needle
to break.
- Do not use bent needles.
- Do not pull or push fabric while stitching. It may deflect the needle.
- Switch the machine off when making any adjustments in the needle area,
such as threading needle, changing needle or changing presser foot and
the like.
( 1 )
English