Electrical - Scotsman C1448 Manuel De L'utilisateur

C1448, C1848, C2148W
Air and Water Cooled User Manual

Electrical

The machine is not supplied with a power cord, one
must either be field installed or the machine
hard-wired.
The dataplate on the back of the cabinet details the
power requirements, including voltage, phase and
maximum fuse size. Extension cords are not
permitted. Use of a licensed electrician is
recommended.
Electrical connections are made inside the junction
box in the back panel of the ice machine.
1 Remove the junction box cover and route the
power cord through the access hole and
properly attach the power supply wires to the
leads in the junction box.
2 Install a field supplied strain relief per code.
Attach a ground wire to the ground connection
in the junction box.
3 Check voltage when complete.
4 Return the junction box cover to its original
position and secure with the original screws.
Follow all applicable codes.
Final Check List
After connections,
1 Wash out the bin. If desired, the interior of the
bin could be sanitized.
2 Locate the ice scoop (if supplied) and have it
available for use when needed.
Final Check List:
1 Is the unit located indoors in a controlled
environment?
2 Is the unit located where it can receive
adequate cooling air?
3 Has the correct electrical power been supplied
to the machine?
4 Have all the water supply connections been
made?
Power
Supply
Wires
5 Have all the drain connections been made?
6 Has the unit been leveled?
7 Have all unpacking materials been removed?
8 Is the water pressure adequate?
9 Have the drain connections been checked for
leaks?
10 Has the bin interior been wiped clean or
sanitized?
11 Have any water filter cartridges been replaced?
12 Have all required kits and adapters been
properly installed?
November 2006
Page 8
Ground Wire
Connection
Install
Strain
Relief