System Master Sheet; Changes To The Design / Construction; Changing The Assembly Location - ATT Nussbaum SPRINTER MOBIL 2500 Manuel D'exploitation

2

System master sheet

2.1 Manufacturer
Nussbaum Custom Lifts GmbH
Hertz Str. 6
D-77694 Kehl-Sundheim
2.2 Purpose
The SPRINTER MOBIL - HYMAX PRO lift is a lifting accessory for the lifting of vehicles up to a total weight of
2,500 kg or 3,000 kg, in normal workshop operation at a maximum load distribution of 3:2 in or against the
drive-in direction.
Additionally, there is a distinction between cars operated with front or rear drive.
The lift is not set up for standing on the receiving plate or for personnel conveyance.
The lift can be used flexibly. Any solid, even surface can be used as a setup location. However, it can also
be fastened to the floor.
The set up of the standard lift is not permitted in explosion endangered work shops.
After construction and significant maintenance changes on load carrying parts the lifting table must be
inspected afterwards by a specialist who approves the changes.
Operation of the lift is done by an operating unit that is located immediately next to the lift.
2.3

Changes to the design / construction

Inspections by a technical expert are required before recommissioning (date, type of change, technical
expert signature).
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Name, address of technical expert
_________________________________________________
Location, date
2.4

Changing the assembly location

Inspections by a technical expert are required before recommissioning (date, type of change, specialist
signature).
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Name, address of technical expert
_________________________________________________
Location, date
OPI_SPRINTER MOBIL 2500-3000_V3.1_DE-EN-FR-ES-IT
_________________________________________________
Technical expert signature
_________________________________________________
Technical expert signature
53