Cleaning; Transport; Storage; Guarantee - ATIKA KS2000-40 Instructions D'utilisation

Cleaning

Clean the chain saw thouroughly after each application so
that the faultless function is kept.
Clean the case with a soft brush or a dry cloth.
Water, solvents and polishing agents shall not be
applied.
Pay attention to that the ventilation slots for the motor
cooling are free (risk of overheating).
After a lomger application period (1 – 3 hours)
disassemble the cover, the sword and the chain and
clean them with a brush.
In case of harder pollution or resins put the chain for
some hours in a container with chain cleaner.
Afterwards wash up the chain with clear water.
Remove all adhering substances with a brush from the
chain wheel and the sword fastening.
Clean the oil flow canal with a clean cloth.
T r a n s p o r t
T r a n s p o r t
Remove mains plug before each

transport.

Transport the chain only with the chain protection put
on.

Storage

Store unused equipment in a dry, locked place out of
the reach of children.
To extend the service life of the saw and guarantee
smooth operation, before storing for a longer period
thoroughly clean the chain saw

Technical data

Typ
Motor rating P
1
Mains voltage
Mains frequency
No-load speed
Mains fuse
Length of sword
Saw chain speed
Oil tank volume max.
Protection class
Braking time of the chain brake
Gewicht
measured sound power level L
guaranteed sound power level L
(measured according to regulation 2000/14/EC)
24
WA
PA
Remove the oil from the oil tank.
Hint:
Some chain oils tend to encrustations after a longer
period. For this reason the oil system should be
flushed before a longer storing with a chain saw
cleaner. Fill the cleaner up to the middle (appr. 50
ml) into the oil tank. Close the tank. Switch on the
chain saw without assembled sword and chain until
the complete cleaner has left the oil opening of the
chain saw.
Put the saw chain for a short time into an oil bath
and enwrap it afterwards in an oil paper.
G u a r a n t e e
G u a r a n t e e
We grant a guarantee of two years, commencing with
the day of delivery from the dealer's store, for material
and manufacturing faults.
Warranty claims, even during the warranty period, will
not be accepted for damages due to incorrect handling
or inadequate packaging during return of the devices or
to a non-observance of the operating instructions.
Faulty parts must be sent to our works, postage or
freight free. We reserve the right to decide upon free
spare part delivery.
Guarantee work will be completed by us or an
authorised servicing agency. Guarantee damage can
only be remedied by another firm with our explicit
approval.
The guarantee does not cover the normal wear of the
saw chain, sword, chain protection, chain wheel and
carbon brushes.
Guarantee is also granted if original spare parts are
used.
Subject to changes in the interest of technical progress.
KS 2000/40
2000 W
230 V~
50 Hz
6800 min –1
16 A inert
400 mm
13.5 m/s
110 ml
ΙΙ /
0.1 sec.
approx. 5,7 kg
103 dB (A)
105 dB (A)
25