Aqara G2H Pro Manuel D'utilisation page 6

NOTICE: If the device addition fails, please confirm the following points：
* The Wi-Fi name or password contains an unsupported special character, such as, @, #, %, -, $,
etc., resulting in a failure to connect to the router. Please change it to a commonly used
character and try again.
* If the camera cannot recognize the QR code generated by the mobile phone. Please make sure
that the screen size of the mobile phone is not less than 4.7 inches, and make sure that you
don't use the backlight of the camera to shoot the QR code.
* Check whether the router has enabled the Wi-Fi anti-squatter setting, which causes the camera
to be unable to connect to the Internet.
* Check whether the router has enabled AP isolation, which leads to the failure to search the
camera on the mobile phone in the LAN.
* Make sure the camera is connected to the 2.4GHz Wi-Fi network.
4 Add accessory
After the Camera Hub G2H Pro is added successfully, please open the Aqara Home
app and refer to the user manual of the accessory to add.
5
Connect to Apple HomeKit
Open the Apple Home app, click "+" on the upper right corner, and then enter the
"Add Accessory" page. Scan or manually enter the HomeKit Setup Code at the
bottom of the camera to bind the camera to HomeKit.
If the camera is failed to add to the HomeKit:
* "Failed to add accessory". Due to multiple adding failures, the error information of the iOS
cache cannot be removed. Please restart the iOS device and reset the camera;
* "Accessory already added". After restarting the iOS device and reset the camera, you can
manually enter the HomeKit setup code and add it again;
03