Vetus SENSORD Manuel D'utilisation Et Instructions D'installation page 44

• Delete value 0.0 using the backspace
function () and enter the height of the
tank. For example, '45' (cm).
This value must now be saved in the
memory.
• Select Enter (

key 1x.
Tank calibration
Tank type
Tank volume
Tank depth
20% tot. depth
40% tot. depth
60% tot. depth
80% tot. depth
Exit
• Return to the menu 'Tank settings' by
using the
to 'Exit' and pressing
• Return to the 'Configuration menu' by
using the
to 'Exit' and pressing
44
090430.01
) and press the
V-shape
123.0 l
45.0 cm
n.a.
n.a.
n.a.
n.a.
/ keys to navigate
.
/ keys to navigate
.
• Connect the next sensor; the name of
the sensor that has just been connect-
ed (Vetus) will be displayed after a brief
interval.
Configuration menu
Tank
Drinking water
Display settings
Exit
Select the sensor that has just been
connected using the
and press
the name of the tank will then be dis-
played again.
Repeat steps B and C for each following
sensor.
For a tank with an irregular shape the vol-
umes at 20, 40, 60 and 80% tot. height
must be entered after this.
This done in the same way as entering the
tank volume and tank height.
Setting the alarms is described in Chapter
'Operating' paragraph 2.4.7.
Ultrasonic tank management system
Vetus
/ keys
2x. The keyboard and