How To Use - Hitachi D 10VH2 Mode D'emploi

English
8. Check the rotational direction (Fig. 4)
The bit rotates clockwise (viewed from the rear side)
by pushing the R-side of the push button.
The L-side of the push button is pushed to turn the bit
counterclockwise.
(The and marks are provided on the body.)
Push Button
9. Installing the side handle (Optional accessory) (Fig. 5)
A Side handle can be installed on either side of the
tool for right or left handed use.
To install the side handle, thread it into the M10 hole
on the desired side of the gear cover and tighten it
securely.
Loosen
10. Attaching the hook. (Optional accessory)
For hook (side-attaching) (Fig. 6)
Fix the hook fi rmly on the desired side of the gear cover
using M10 bolt which is supplied with hook.
M10 Bolt
Hook
CAUTION
When the power tool is used with a hook fi xed to
it, pay attention to the following points:
● Before hanging the main unit from the waist belt,
make sure that the drill has come to a complete
stop.
While it is suspended from the waist belt, the
power plug must be disconnected from the power
source.
● Do not walk about with the power tool hanging
from the waist belot.
8
mark
Switch Trigger
mark
Fig. 4
Side handle
Tighten
Fig. 5
Fig. 6
● In the case of operation in a high place, it is
dangerous to drop the tool accidentally. If
the hook is deformed or hung from the wrong
position, there is danger that the hook will slip
off and the tool will fall.
Be careful to avoid danger.
● In making a through hole, the power tool
sometimes shakes violently when the workpiece
is pierced, from example. Be careful you are not
hurt by the hook even if such situation happens.

HOW TO USE

CAUTION
To prevent accidents, make sure to turn the switch
off and disconnect the plug from the receptacle
when the drill bits and other various parts are
installed or removed. The power switch should
also be turned off during a work break and after
work.
1. Switch operation
○ When the trigger switch is depressed, the tool rotates.
When the trigger is released, the tool stops.
○ The rotational speed of the drill can be controlled by
varying the amount that the Trigger switch is pulled.
Speed is low when the trigger switch is pulled slightly
and increases as the trigger switch is pulled more.
○ The desired rotation speed can be pre-selected with
the speed control dial.
Turn the speed control dial clockwise for higher speed
and counterclockwise for lower speed. (Fig. 7)
Speed
control dial
Low speed
○ Pulling the trigger and pushing the stopper, it keeps
the switched-on condition which is convenient for
continuous running. When switching off , the stopper
can be disconnected by pulling the trigger again.
2. Drilling
○ When drilling, start the drill slowly, and gradually
increasing speed as you drill.
○ Always apply pressure in a straight line with the bit.
Use enough pressure to keep drilling, but do not push
hard enough to stall the motor or defl ect the bit.
○ To minimize stalling or breaking through the material,
reduce pressure on drill and ease the bit through the
last part of the hole.
○ If the drill stalls, release the trigger immediately,
remove the bit from the work and start again. Do not
click the trigger on and off in an attempt to start a
stalled drill. This can damage the drill.
Stopper
High speed
Fig. 7