SOLAC MD7411 Mode D'emploi page 15

- When the strand of hair is
positioned properly, close the
lever (E), you will see that the
hair rolls up inside the device
automatically (Fig.3).
- Hold the device and follow
the acoustic guide for ease of
use: 8 heating beeps + 3 end
of application beeps Open the
lever (E) and allow the curl to
fall out slowly. (Fig.4).
- Note: do not pull on the device
to release the hair, otherwise
you will undo the curl.
- Allow the hair to cool before
handling or combing it.
- Do the same with the rest of
your hair until you achieve the
desired number of curls.
ONCE YOU HAVE FINISHED
USING THE APPLIANCE:
- Turn the appliance off, using
the on/off switch.
- Unplug the appliance from the
mains.
- Clean the appliance.
CLEANING
- Disconnect the appliance
from the mains and allow it to
cool before undertaking any
cleaning task.
- Clean the equipment with a
damp cloth with a few drops of
washing-up liquid and then dry.
- Do not use solvents, or prod-
ucts with an acid or base pH
such as bleach, or abrasive
products, for cleaning the
appliance.
- Never submerge the appliance
in water or any other liquid or
place it under running water.
ANOMALIES AND
REPAIR
- Take the appliance to an
authorised technical support
service if product is damaged
or other problems arise. Do
not attempt to disassemble or
repair the appliance yourself
as this may be dangerous.
FOR EU PRODUCT VERSIONS
AND/OR IN CASE THAT IT
IS REQUESTED IN YOUR
COUNTRY:
ECOLOGY AND RECYCLABIL-
ITY OF THE PRODUCT
- The materials of which the
packaging of this appliance
consists are included in a
collection, classification and
recycling system. Should
you wish to dispose of them,
use the appropriate public