Lighting The Side Burner - Weber Spirit 89962 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

When the "excess gas flow control" feature is activated,
a small amount of gas is still flowing to the burners. After
turning OFF the cylinder and burner control knobs, wait at
least 5 minutes for the gas to clear before attempting to light
the barbecue. Failure to do so may result in an explosive
flame-up, which can cause serious bodily injury or death.
3)
Turn the cylinder on by turning the cylinder valve counterclockwise.
4)
Insert match holder with lit match into the matchlight hole in the front of the
cooking box.
WARNING: Do not lean over open barbecue. Keep your face
and body at least one foot away from the matchlight hole
when lighting the barbecue.
5)
Push BURNER 1 control knob down and turn to START/HI.
6)
Check that the burner is lit by looking through the matchlight hole on the front of
the cooking box. You should see a flame.
WARNING: If the burner does not light in five seconds, turn
the Burner 1 control knob to OFF and wait 5 minutes to let
the gas clear before you try again.
7)
After BURNER 1 is lit you can turn on BURNER 2 (and BURNER 3).
Note - Always light BURNER 1 first. The other burners ignite from BURNER 1.
TO EXTINGUISH
Push down and turn each burner control knob clockwise to the OFF position. Turn gas
supply OFF at the source.

LIGHTING THE SIDE BURNER

Failure to open the lid while igniting the side burner, or not
waiting 5 minutes to allow the gas to clear if the side burner
does not light, may result in an explosive flame-up which can
cause serious bodily injury or death.
WARNING: Check hose before each use of barbecue for nicks,
cracking, abrasions or cuts. If the hose is found to be damaged
in any way, do not use the barbecue. Replace using only Weber
authorized replacement hose. Contact the Customer Service
Representative in your area using the contact information on
our web site. Log onto www.weber.com
1)
Open the side burner lid.
2)
Check that the side burner valve is turned off (Push control knob in and turn
clockwise to ensure that it is in the "OFF" position), turn all burners not being used
to the "OFF" position (push in and turn clockwise).
3)
Turn the gas supply valve on.
4)
Push down and turn the side burner control valve to "HI".
5)
Press the igniter button several times so it clicks each time.
CAUTION: Side burner flame may be difficult to see on a
bright sunny day.
WARNING: If the side burner does not light in five (5)
seconds:
a)
Turn off the side burner control valve, main burners
and gas supply at source.
b)
Wait 5 minutes to let the gas clear before you try
again, or try lighting with a match (see "Manually
Lighting the Side Burner").
WWW.WEBER.COM
®
OPERATING INSTRUCTIONS
DANGER
DANGER
®
.
MAIN BURNER MANUAL LIGHTING
2
OFF
APAGADO
1
ARRETE
5
* The grill illustrated may have
slight differences than the
model purchased.
SIDE BURNER LIGHTING
* The grill illustrated may have
slight differences than the
model purchased.
®
1
2
4
13
1
2
4
6
5
3
2
5
3
13
7

Publicité

Table des Matières
loading

Table des Matières