Applications; Installing/Removing Battery Pack; Operation - Ryobi PBLAG01 Manuel D'utilisation

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.

APPLICATIONS

You may use this product for the purpose listed below:
 Grinding metals
 Cutting metals such as sheet steel, pipe, steel rods,
aluminum, brass, and copper
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always in the OFF position
when not in use or carrying at your side.

INSTALLING/REMOVING BATTERY PACK

See Figure 6, page 13.
To install:
 Insert the battery pack.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
To remove:
 Depress the latches on each side of the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.

OPERATION

STARTING/STOPPING CUT-OFF TOOL/
GRINDER
See Figure 7, page 13.
To turn the tool ON:
 Install the battery pack.
 Hold the tool in front and away from you, keeping the
wheel clear of the workpiece.
 To start the tool, grasp the handle and side handle firmly.
Push the lock-out switch forward and squeeze the paddle
switch.
To turn the tool OFF:
 To stop the tool, release the paddle switch. Make sure
the tool comes to a complete stop before laying down
the tool.
POSITIONING THE WHEEL GUARD
See Figures 8 - 12, pages 13 and 14.
NOTE: The procedure for positioning the wheel guard is the
same with or without the guard insert attached.
The wheel guard on the tool should be correctly positioned
depending on which location the side handle is mounted
and depending on what type of operation you are performing
(cutting or grinding). Never use the tool without a wheel guard
correctly in place or when the index arrows are aligned.
WARNING:
Never place the wheel guard so that it is in front of the
tool. This could result in serious injury because sparks
and loose particles thrown from the grinding or cutting
wheel would be directed toward the operator. Always
place the wheel guard in the correct location as shown.
To adjust the wheel guard:
 Remove the battery pack.
 Depress lever and rotate the guard to its correct position
as shown.
NOTE: Be sure the raised ridge on the guard is seated in
the groove on the bearing cap. Never use the tool without
a guard in place and properly adjusted.
GRINDING WITH THE TOOL
See Figure 13, page 14.
Always carefully select and use grinding wheels that are
recommended for the material to be ground. Make sure
that the minimum operating speed of any accessory wheel
selected is 9,200/min. or more. The grinding wheel provided
with the tool is suitable for grinding welds, preparing surfaces
to be welded, grinding structural steel, and grinding stainless
steel.
9 — English