Transport; Guarantee; Possible Faults - ATIKA HHS 710/56 Notice Originale

Transport

Remove mains plug before each transport.
 Transport the device only with the blade guard pushed on to
avoid injuries or damages.
 Carry the device balanced on the shaft or hanging from the
carrying strap. Hold the cutting tool toward the back at this.
 When transporting the product within a car put it in the boot
or on a separate loading area.
 You may pull the device apart to save space.
 Do not throw the device when loading it. Secure the device
against tipping over or damages.
Check the device for damages if it was subjected to hard
jolts during transport.
Fault
Hedge trimmer does not work.
Hedge trimmer cuts
interruptions
Motor is running, knives do not
move
Knives get hot
Motor is humming, knives do not
move

In case of further faults or inquiries please contact your local dealer.

Possible faults

Possible cause
 No power
 Power failure
 Extension cable defect
 Safety fuse defect
 Motor or switch defect
with  Cable defect
 Internal failure
 Circuit closer/breaker defect
 Internal failure
 Knives are edgeless
 Knives are defect
 Missing lubrication => friction
 Knives are blocking
Storage
Remove the mains plug from the socket.
 Store unused devices with attached protective cover in a dry,
locked place out of the reach of children.
 To extend the service life of the hedge trimmer and
guarantee smooth operation, before storing for a longer
period
thoroughly clean the hedge trimmer
-
treat all movable parts with an environmentally friendly
-
oil

Never use any grease!

Push the knife protection on the knife.

Guarantee

Please observe the enclosed terms of guarantee.
Removal (disconnect power plug)
 Check cable, no longer use defect cable protection
 Check cable, no longer use defect cable protection
 Check power supply, power outlet, fuse
 Replace fuse
 Have motor or switch checked by an approved
electrician or replaced by original spare parts
 Check cable, no longer use defect cable protection
 Manufacturer
service respectively must be called
 Manufacturer or responsible customer service
respectively must be called
 Manufacturer or responsible customer service
respectively must be called
 Arrange sharpening of knives
 Exchange knives
 Lubricating of knives
 Remove object
or responsible customer
23