Ir Operation Without Ebode Switcher Or Splitter As Stand-Alone Kit; Cec Operation With Ebode Switcher Or Splitter; Cec Operation Without Ebode Switcher Or Splitter As Stand-Alone Kit - Ebode HDIK30 Guide Utilisateur

6. IR operation without ebode switcher or splitter as stand-alone kit

 When using this IR over HDMI kit without any of our switchers you would need two
adapters.
 Take the HDMI cable out of the TV and put the adapter on the HDMI cable.
 Put the HDMI cable with adapter back into your TV.
 Connect the IR receiver to the adapter at the TV side and place the Receiver on a good
clear visible spot near your TV so you can point at it with the remote of the source
(DVD, STB etc.).
 Set the tiny switcher on both adapters to "IR".
 Take the HDMI cable out of the source (DVD, STB etc.) and put the adapter on the
HDMI cable.
 Put the HDMI cable with adapter back into the source.
 Connect the Blaster to the IR output on the adapter at the source side and place the
Blaster in front but within 2 meters of your source or sources such as DVD, STB etc. It
is no problem if the sources are in a closed cabinet as long as the Blaster has clear
visibility to the IR receiving windows on each device.
 Test your IR over HDMI connection by pointing the remote of the source of your choice
to the IR Receiver and send an IR command such as power-on. Please verify if the
source is powered and ready to receive IR commands by controlling it directly first.

7. CEC operation with ebode switcher or splitter

 When using the HDIK30 kit with the ebode HDMI splitters (HDISPLIT12 & HDSPLIT14)
or switchers (HDSWITCH31 & HDSWITCH51) you would only need 1 adapter to send
the IR signal from the TV to the source (DVD, STB etc.). The receiving adapter is built
into our switchers and splitters.
 Take the HDMI cable out of the TV and put the adapter on the HDMI cable.
 Put the HDMI cable with adapter back into your TV.
 Set the tiny switcher on the adapter at the TV side to "CEC".
 Look into the manual of your TV and Source and make sure both have CEC enabled. If
not the CEC feature cannot work.
 Test your IR over HDMI connection by pointing the remote of the source of your choice
to the IR Receiving Window of your TV and send an IR command such as power-on.
Please verify if the source and TV are powered and ready to receive IR commands by
controlling it directly first.

8. CEC operation without ebode switcher or splitter as stand-alone kit

 When using this IR over HDMI kit without any of our switchers you would need two
adapters.
 Take the HDMI cable out of the TV and put the adapter on the HDMI cable.
 Put the HDMI cable with adapter back into your TV.
 Connect the IR receiver to the adapter at the TV side and place the Receiver on a good
clear visible spot near your TV so you can point at it with the remote of the source
(DVD, STB etc.).
 Take the HDMI cable out of the source (DVD, STB etc.) and put the adapter on the
HDMI cable.
 Put the HDMI cable with adapter back into the source.
 Set the tiny switcher on both adapters to "CEC".
 Look into the manual of your TV and Source and make sure both have CEC enabled. If
not the CEC feature cannot work.
 Test your IR over HDMI connection by pointing the remote of the source to the IR
Receiving Window of your TV and send an IR command such as power-on. Please verify
if both the source and TV are powered on and ready to receive IR commands by
controlling it directly first.
10-9-2013 4 ebode HDIK30