Control Panel - Kuppersbusch ITE1260-1 Notice D'utilisation

• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban

Control panel

1 Pilot light
2 Temperature regulator
3 Fast Freezing light
4 Fast Freezing switch
5 Alarm light
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise
to a medium setting.
The pilot light will light up.
Important! If the temperature inside the
appliance is too high the Alarm light will
blink. Active the Fast freezing function.
Switching off
To turn off the appliance, turn the Tempera-
ture regulator to the "O" position.
The pilot light will switch off.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as fol-
lows:
• turn the Temperature regulator toward
lower settings to obtain the minimum
coldness.
• turn the Temperature regulator toward
higher settings to obtain the maximum
coldness.
1 2 3 4
However, the exact setting should be chos-
en keeping in mind that the temperature in-
side the appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Fast freezing function
You can activate the Fast freezing function
by pressing the Fast freezing switch.
The Fast freezing light will light up.
This function stops automatically after 52
hours.
It is possible to deactivate the function at
any time by pressing Fast freezing switch.
The Fast freezing light will switch off.
Excessive temperature alarm
An increase in the temperature in a com-
partment (for example due to an power fail-
ure) is indicated by flashing of the Alarm
light.
When normal conditions are restored the
Alarm light will switch off automatically.
refuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol are recyclable.
5
A medium setting is generally the most
suitable.
17